Auto Test is the most advanced lead-acid battery tester which uses a unique Pulse-Impedance technology.

Auto Test is the most advanced lead-acid battery tested which also a unique Pulse-Impedance technology. Auto Test enables the user to test the Amp-hour rate, cold cranking Ampls and internal resistance.

AUTOTEST ELECTRONICS ANALYZER IN DETAIL
Autotest has three modes of operation: Managed Mode, Measurement Mode and Menu mode

Managed Mode
Managed Mode is a microprocessor managed diagnostic sequence that evaluates battery condition, alternator/regulator output, integrity of battery clamps to battery post connections, and the level of "key off" drain.

The technology utilized by Autotest was developed to accommodate varying states of battery charge, and in particular the very low states of charge typically encountered by roadside service providers, the battery analysis sequence operates from 30 seconds to 4 minutes depending on battery's state of charge.

At the conclusion of a diagnostic sequence Autotest displays the results for battery, alternator/regulator and "key off" drain. The data in support of the results is also available if required and can be printed out. A coded summary for subsequent data transfer and analysis if required.

Measurement Mode
Measurement Mode provides for auto-ranging DC multimeter functions (volts, amps, ohms). AC measurements reported separately as RMS volts, peak to peak volts, positive duty cycle in % for the square wave, mS 'on time' and frequency of the AC waveform for ECU diagnostics, starter check and battery analysis. Battery condition is reported to the operator as Pass/Marginal/Fall with the test data expressed as the final loaded voltage equivalent to a standard BCI (Battery Council International) load test.

Menu Mode
Autotest has a Menu Mode to enable data printing and downloads, data storage and selection of battery rating standard (SAE, DIN, IEC, EN)

SPECIFICATIONS

Battery Tests
Unique Pulse Impendence Test (determines equivalent BCI loaded voltage to + 0.2V typical)

Shorted Cells Test
Open Cell Test
High Resistance Test (sulphation)
Charge Acceptance Test
Terminal Corrosion Test
(All tests automatically temperature compensated)

Measurement Ranges
DC Volts:                        +0.01V to +40.00V (auto-ranging)
DC Amps:                       +0.1A to +750A (auto-ranging)
Ohms:                             0.1Ohm to 60kOhms (auto-ranging)
Continuity:                      Beep for < 5 Ohms
AC Volts:                        0.01V to 40.00V RMS
Duty Cycle:                     0% to 100%
Pulse width:                     0.0mS to 10.0mS
Frequency:                      50Hz to 10kHz
Battery type:                   12 Volt Lead Acid
Range:                           200 to 1000 CCA (SAE) Equivalent ranges for DIN, IEC and EN.

Physical detail
Case Dimensions:           210 mm x 140 mm x 40 mm
Weight:                          1100 g
Display:                         80 char (20 x 4) backlit LCD
Data port:                      RS232C
Operating Temperatures: -10C to + 60C
Weather Sealing:            Splash Resistant, non-immersible
Power:                           Internal 1.2 Ah sealed rechargeable battery. Auto charging

Price
Php 118,750.00 , landed cost Metro Manila
Made in USA
1 year warranty on parts and service



Contact us for more details:
Maxx-Energie Ventures Corp
GF Bldg 3 Jannov Plaza
2295 Pasong Tamo Ext,
Makati City, MM, Philippines

Tel: +632-892-8980
Fax: +632-8137122
e-mail: maxxenergie@vasia.com